3 thoughts on “How to let it bulge when the gold bracelet is recessed”

  1. There is no way, it can only be melted in another shape.
    The maintenance method before the gold is not deformed:
    In goats to wait:
    The golden bead bracelets must be wiped out after cleaning. It is best to use sheepskin, do not use noodle paper, because some noodle paper friction will wear golden beads.
    This away from the kitchen:
    The surface of the golden beads has tiny pores, so it should not be allowed to inhale the dirty substance in the air. Golden beads absorb eruption, perfume and other substances. So do not wear beautiful golden bead bracelets to electrode, and be careful in the kitchen. Don't wear beautiful golden beads to cook vegetables, steam and oil fume can penetrate into the golden beads and make it yellow.
    The air:
    sm not to put the golden bead bracelet in the safe for a long time, and do not seal it with a rubber bag. Fresh air is needed between golden beads, and every few months will be taken out to make them breathe. If the golden beads in the box will become yellow for a long time.
    The fixing jewelry box:
    This is stored in a soft bag or in a jewelry box to avoid the hard side, angle directly touching and the surface of the golden beads on the surface of the metal or stone and leaving scratches.
    three -year changes:
    The best chain of gold bead bracelets is best skewed every three years. Entering the dirt into the small hole of the beads will produce friction and break the nylon thread.
    This water:
    do not clean the golden bead bracelet with water. Water can enter the small hole of the beads. It is not only difficult to dry, but it may also ferment inside, and the bead thread may also turn green. If you have a lot of sweat when you wear, you can use a soft and wet towel to clean it carefully, and save it after air drying.

  2. Because the texture is soft, it is easy to deform when wearing.
    If deformation, it is recommended to take it to the gold shop for maintenance, so as not to cause more severe damage to your own operation errors.

Leave a Comment