5 thoughts on “How can I give the dog intravenous infusion, where is the specific location?”
Patti
Dog intravenous infusion method:
The first step, put on rubber bands on the forehead of the dog. Ip: The blood flow back to the blood after ligation, the venous pressure is swollen, which is easy to find the blood vessel tieder. After tie the rubber band, wait for a while to wait for the vein to swell. Step 2, hold up the dog's forearm to observe the blood vessels. 1. Press the skin below the ligation with your fingers. There are obvious bulges, good elasticity, and sliding parts, which are usually the veins where the compression and expansion are. 2, when stitching, try to choose the thicker and not easily sliding veins for injection. 3, I personally think that: the first joint is about 3 cm up, and there is a slightly inside, which is the best venous injection. This is the vein of the front leg. 4. If the vein position cannot be accurately grasped, the dog hair can be shaved. The third step, pierce the needle. 1. Let the dog lie down or sit down, soothe the dog to eliminate the tension. 2, the left hand holds the dog's front leg, and use the fingers to fix the skin at the vein as much as possible to avoid excessive sliding by the vein under the stress. 3, the right hand holds a syringe, the needle and the skin are pierced into the vein 90 degrees or 45 degrees angle. (there is a blood recovery after the piercing, be careful not to pierce the venous blood vessel wall when pushing into the needle. No blood indicates that the piercing is pierced in the non -vein.) 4. Before the vein is pierced, be sure to check whether the syringe is blocked and discharge inside the tube. All air, until the needle flows out of the needle to avoid veins of air intake. 5, hold down the needle, take off the rubber band, open the drip, and adjust the drop speed to appropriate. Is when the syringe has blood back, the rubber band should be removed in time to open the drip to return the blood. Time will cause blood condensation and the drops of the drops. At this time, the syringe must be replaced. 6. Before fixed needles, observe the injection situation and dog status, such as: whether there is a bulging under the skin, whether the drip speed is normal, whether the blood is returned, whether the dog is low, whether the dog is restless. If the above situation appears, it indicates that the needle pierces through the blood vessel wall or is too deep, causing the subcutaneous bulge and the dog's discomfort. If a needle is repeatedly pierced, it may be condensed by subcutaneous hemorrhage, which causes the drops to poor drops. At this time, the syringe should be replaced. 7, fix the needle with a tape. The fourth step, pull the needle. The drop of drops, press the cotton to quickly pull out the needle at the piercing place, press the cotton to stop the bleeding for 1-2 minutes, and confirm that there is no bleeding before leaving. In the infusion process, please pay close attention to the dogs. At this time, the dog is usually extremely sensitive due to the fragility of the body. For example, the sound of the outside world and the collision of the dog can easily cause the dog's severe response. The action is too large. It is easy to cause the needle misalignment.
I think if you love dogs. You should not take a dog as an experiment. It is best to go to the veterinarian is the most appropriate. I hope useful to you.
n00:00 / 07: 1170% shortcut keys to describe space: Play / suspend ESC: exit full screen ↑: increase volume 10% ↓: decreases by 10% →: Single fast forward 5 seconds studio Here you can drag no longer appear in the player settings to reopen the small window shortcut key description
Dog intravenous infusion method:
The first step, put on rubber bands on the forehead of the dog.
Ip: The blood flow back to the blood after ligation, the venous pressure is swollen, which is easy to find the blood vessel tieder. After tie the rubber band, wait for a while to wait for the vein to swell.
Step 2, hold up the dog's forearm to observe the blood vessels.
1. Press the skin below the ligation with your fingers. There are obvious bulges, good elasticity, and sliding parts, which are usually the veins where the compression and expansion are.
2, when stitching, try to choose the thicker and not easily sliding veins for injection.
3, I personally think that: the first joint is about 3 cm up, and there is a slightly inside, which is the best venous injection. This is the vein of the front leg.
4. If the vein position cannot be accurately grasped, the dog hair can be shaved.
The third step, pierce the needle.
1. Let the dog lie down or sit down, soothe the dog to eliminate the tension.
2, the left hand holds the dog's front leg, and use the fingers to fix the skin at the vein as much as possible to avoid excessive sliding by the vein under the stress.
3, the right hand holds a syringe, the needle and the skin are pierced into the vein 90 degrees or 45 degrees angle.
(there is a blood recovery after the piercing, be careful not to pierce the venous blood vessel wall when pushing into the needle. No blood indicates that the piercing is pierced in the non -vein.) 4. Before the vein is pierced, be sure to check whether the syringe is blocked and discharge inside the tube. All air, until the needle flows out of the needle to avoid veins of air intake.
5, hold down the needle, take off the rubber band, open the drip, and adjust the drop speed to appropriate.
Is when the syringe has blood back, the rubber band should be removed in time to open the drip to return the blood. Time will cause blood condensation and the drops of the drops. At this time, the syringe must be replaced.
6. Before fixed needles, observe the injection situation and dog status, such as: whether there is a bulging under the skin, whether the drip speed is normal, whether the blood is returned, whether the dog is low, whether the dog is restless.
If the above situation appears, it indicates that the needle pierces through the blood vessel wall or is too deep, causing the subcutaneous bulge and the dog's discomfort.
If a needle is repeatedly pierced, it may be condensed by subcutaneous hemorrhage, which causes the drops to poor drops. At this time, the syringe should be replaced.
7, fix the needle with a tape.
The fourth step, pull the needle.
The drop of drops, press the cotton to quickly pull out the needle at the piercing place, press the cotton to stop the bleeding for 1-2 minutes, and confirm that there is no bleeding before leaving.
In the infusion process, please pay close attention to the dogs. At this time, the dog is usually extremely sensitive due to the fragility of the body. For example, the sound of the outside world and the collision of the dog can easily cause the dog's severe response. The action is too large. It is easy to cause the needle misalignment.
This is how the puppy infusion is lost in the front paw like this
I think if you love dogs. You should not take a dog as an experiment. It is best to go to the veterinarian is the most appropriate. I hope useful to you.
20191209 Pet Varician Infusion
n00:00 / 07: 1170% shortcut keys to describe space: Play / suspend ESC: exit full screen ↑: increase volume 10% ↓: decreases by 10% →: Single fast forward 5 seconds studio Here you can drag no longer appear in the player settings to reopen the small window shortcut key description
Where is the dog infusion site